Home > Knowledgebase > How do I configure my own, unlocked LinkSys SPA2102 with ViaTalk?
| How do I configure my own, unlocked LinkSys SPA2102 with ViaTalk? |
These instructions assume that you are utilizing a computer that is plugged into the Ethernet port of a non-branded or unlocked LinkSys SPA2102.
1) Open a web browser (Internet Explorer, Safari, etc.) and copy/paste the following link into the address bar:
http://192.168.0.1/admin/voice/advanced/
2) You will be prompted to enter your administrative username and password.
username: admin
password:
3) Click the 'Line 1' tab at the top of the page. Once the page loads, you will see the information for your adapter's configuration.
(You may open a separate browser window and visit your ViaTalk Control Panel to view your credentials found under the 'Softphone Configuration' icon.)
Proxy:
Display Name:
User ID:
Password:
DTMF Tx Method: Auto
4) Click the 'Submit All Changes' link at the bottom of the page.
Once this is complete, in approximately one minute you should see the Phone 1 light lit on the device. Plug a standard, touch-tone phone into the Phone 1 port to confirm dial tone, and you may then begin placing calls!
|
|
Rating:  (4711 Votes)
Was this answer helpful?:  Yes  No |
|
|
|
