Lost your password? | Close Panel

Technical Support

Home > Knowledgebase > How do I reboot my adapter?

How do I reboot my adapter?
How To Reset My Linksys Phone Adapter

• To reset your adapter you want to first pull out the power plug on the back of your high speed broadband modem and then do the same on your router, if you have one.

• Then you want to unplug the power plug from the ViaTalk phone adapter, just like you did with the modem and router.

• Then, wait a minute or two and plug your modem in first, then your router, then your ViaTalk phone adapter.

• You should wait a minute until all three of the lights on the phone adapter light up.

• Check your internet connection on your computer to see if you have a good connection (You may have to restart your computer).

• Last check to see if you have a dial tone on your phone.
Rating: (7167 Votes)
Was this answer helpful?: Yes   No
Related Topics
How do I connect my computer and adapter?

Why would I want to reboot my adapter?

How do I setup my ViaTalk LinkSys PAP2 or Cisco 112 adapter?

Will ViaTalk work throughout my home?

Print Article
Add to Favorites
Rate this Article